Troubleshooting First Loop

From Loopy Pro Wiki
Revision as of 02:41, 7 August 2024 by Razzi (talk | contribs) (→‎Setup: Mis-used word “say” in place of now-corrected “see”)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Troubleshooting Your First Loop

If you are running into problems getting started, this page is intended to help you get started. If things don't work out as described, the problems you encounter will provide clues about what is going wrong.

Need a simple project and a first lesson? Check out the Simple Looper article.

Getting Started

  • Completely power down your device (using "slide to power off") rather than just putting it to sleep
  • Disconnect all peripherals
  • Power up your device

If Using Internal Headphones And Touch

Headphones are recommended when using Loopy Pro with a microphone (to avoid feedback and maximize audio playback)

Setup

  • Plug in your headphone
  • Launch Loopy Pro
  • Create a new project
  • Choose Clip Settings from the main menu
  • Scroll to the bottom and choose Restore Defaults
  • Choose System Settings from Loopy's main menu and make sure Multiroute Audio is turned OFF.
  • Pop-up loopy's mixer
  • If the mic input channel is muted, unmute it
  • Check the level: speak or sing at the level you want to record at. If you see any red in the meters, lower the input channel's fader
  • You can close the mixer now so that you have the clips area available at full size.

Recording the First Loop

  • Put your finger down on an empty loop (but don't remove it yet)
  • When ready to start recording, remove your finger and start speaking or singing
  • Slightly ahead of when you want the recording to step, put your finger back down on the clip.
  • Remove your finger at the moment that you want the recording to end.

The clip you just recorded should be playing back distortion free.

This video demonstrates what should happen. You can watch it at full size on YouTube.

If you perform the steps described above and something different happens than what is shown in the video, please create a screen recording (https://support.apple.com/en-us/HT207935) to demonstrate what happens.

When making your screen recording:

  • please include a view of the System Settings by choosing System Settings from Loopy Pro's main menu
  • please show the input channel's settings (by tapping on the input channel's icon at the top of the channel) so that we can see the mic choice and other settings.

See Also

The Loopy Pro Manual has some helpful information about recording the first loop.

These videos might be helpful, too:

  • Michael’s recording tips
  • Max Yar’s tips for recording acoustic guitar loops
Retrieved from "https://wiki.loopypro.com/index.php?title=Troubleshooting_First_Loop&oldid=384"